Selector Shaft, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, and 2014 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing T40216 On Selector Shaft

Courtesy of AUDI OF AMERICA, LLC

-- Install the new o-ring on the selector shaft cover -2-.

-- Remove the Selector Shaft Guide Pins T40216 on the gearshift shaft -1-.

-- Install the gearshift shaft into the transmission -arrow A- and lift it slightly -arrow B-.

Fig 2: Installing Gearshift Shaft Into Transmission And Lift It Slightly

Courtesy of AUDI OF AMERICA, LLC

-- Bring the selector shaft cover -2- into contact with the transmission housing.

Fig 3: Bring Selector Shaft Cover -2- Into Contact With Transmission Cover

Courtesy of AUDI OF AMERICA, LLC

-- Install new bolts -1- and tighten them. Tightening specification. Refer to -item 14- (See Figure).

-- Remove the Selector Shaft Guide Pin T40216.