Overview - Wheel Set, Reverse Drive Gear, Gearshift Mechanism
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, and 2014 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
- Transmission Housing
- With differential and pinion
- Different versions
- Allocate correct version
- Magnet
- Clean off
- Plug
- Quantity: 2
- Depending on the version installed from MY 2012
- Installation position. Refer to Fig 3
- Omitted on transmissions with heater core, refer to -item 4-.
- Heat Exchanger
- For transmission fluid heater
- Depending on the version installed from MY 2012
- Removing and installing. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .
- O-Ring
- Quantity: 2
- For heat exchanger or plug
- Always replace.
- Install in the front groove on the plug or heat exchanger
- O-Ring
- Quantity: 2
- For transmission fluid heater or plug
- Always replace.
- Install in the rear groove on the plug or heat exchanger
- Oil Catch Tray
- Clipped into the bearing bracket and the gearshift rail/shift fork for 3rd and 4th gears
- Gear Set
- Made up of input and output shaft with shift fork group
- Disassembling and assembling. Refer to GEARS AND SHAFTS, DISASSEMBLING AND ASSEMBLING .
- Reverse Drive Gear
- With support/reverse shaft
- Reverse drive gear assembly overview; refer to. Refer to Fig 2
1 - Thrust Washer
2 - Needle Bearing
3 - Reverse Drive Gear
Installed position: The shoulder -arrow- faces the transmission housing.
4 - Reverse shaft support
NOTE:
For transmission housing equipped with internal transmission fluid heating, it will be equipped with plug -1- in the transmission housing -4- instead of a heat exchanger.
Always replace the o-rings -2 to 3-.