Shift Lock Solenoid -N110-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2018 Audi S6, 2017 Audi S6, 2016 Audi S6, 2016 Audi S4, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Tightening specification. Refer to OVERVIEW - SELECTOR MECHANISM .

-- Turn the ball head -1- into the correct installed position.

-- Install the Shift Lock Solenoid -N110- at an angle into the selector mechanism and then tilt it opposite the direction of -arrow-.

The ball head -1- must engage completely in the operating lever on shift mechanism. Press it down using a small screwdriver if necessary.

Fig 1: Pressing Retaining Hooks Into Shift Mechanism
Courtesy of AUDI OF AMERICA, LLC

-- Attach the Shift Lock Solenoid -N110- to the hook -A-.

-- Position the cover -A- over the Shift Lock Solenoid -N110- and carefully lock it in -1 through 3-.

Fig 2: Sealing Cap, Bracket And Tabs

Courtesy of AUDI OF AMERICA, LLC

-- Connect the electrical connectors.

-- Check the shift mechanism function before completing assembly. Refer to GEARSHIFT MECHANISM, CHECKING .

-- Install the front ashtray. Refer to FRONT ASHTRAY, REMOVING AND INSTALLING .

-- Install the Multimedia System Control Head -E380-. Refer to Multimedia System Control Head -E380-, REMOVING AND INSTALLING .