Overview - SUBFRAME Mount
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2018 Audi S6, 2017 Audi S6, 2016 Audi S6, 2016 Audi S4, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
- Nut
- 20 Nm
- Bolt
- 70 Nm
- Bolt
- 40 Nm
- Nut
- 20 Nm
- Transmission Support
- Removing and Installing. Refer to TRANSMISSION SUPPORT WITH TRANSMISSION MOUNT, REMOVING AND INSTALLING
- Transmission Mount
- Removing and Installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING
- Lower Stop
- For the transmission mount
- Bolt
- 20 Nm
- Tunnel Crossmember
- Removing and Installing. Refer to TUNNEL CROSSMEMBER, REMOVING AND INSTALLING
- Depending on the date of manufacture, an additional air guide for cooling the self-locking center differential is attached to the bottom of the tunnel crossmember. Refer to Fig 2.
- Bolt tightening specification -arrows-, 3 Nm