ATF Cooler, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2018 Audi S6, 2017 Audi S6, 2016 Audi S6, 2016 Audi S4, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Danger of leaks!
- Always replace the seals on the oil lines and the filter housing and coat with ATF.
- Ensure a clean sealing surface.
CAUTION:
Risk of damaging the transmission
- When disassembling, remove all the plugs, which were taken from the Engine Bung Set -VAS6122-, and the ATF line/hose line and from the transmission.
- The ATF cooling function will not work and the transmission will be damaged if the plugs are forgotten.
Install in reverse order of removal. At the same time note the following:
- Clean the sealing surfaces and replace the oil line seals.
- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING .