LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 512 (Exterior Body Panels (Hood, Lids) (Sedan)) >> (55 Hood, Lids) >> Rear Lid >> Lid Latch, Removing And Installing >> Rear Lid Lock, Removing And Installing, Sedan

Rear Lid Lock, Removing And Installing, Sedan

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Rear Lid Lock
GWWA55-10339Courtesy of AUDI OF AMERICA, LLC
  1. Cover
    • Before removing the lid trim, remove from the lid latch
  2. Nut
    • 21 Nm
  3. Cover for Lid Latch
    • When installing, cover must engage audibly in lid latch.
  4. Lid Latch
    • Before removal, remove the lid latch cover.
    • The rear lid trim panel is removed. Refer to COMPONENT LOCATION OVERVIEW - REAR LID TRIM PANELS .
    • Disconnect the connector.
    • If necessary, disengage the emergency release cable.
    • Remove nuts and remove lid latch.
    • Remove the lid latch with the clip from the centering hole.
  5. Centering Hole
  6. Centering Clip
    • To install, first press the lid lock with the clip into the centering hole.
scientia non olet · About LEMON Manuals