Calibration Board Alignment

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Position the calibration platform behind the vehicle at a distance of 1.47 m to 1.90 m to the rear wheels, see -dimension A- in the illustration, refer to Calibration Tool VAS6350, INSTALLING AND ALIGNING => Installed Calibration Tool VAS6350 .

-- Bring the Calibration Tool VAS6350 into a horizontal position.

-- To do so, twist plastic feet under calibration platform so that air bubble in the level is located exactly in the center of the indicator -arrow-.

Fig 1: Identifying Bubble Level (Sight Glass) On Calibration Tool VAS 6350

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Make sure light does not reflect off the calibration platform.

Reflections affect the Rearview Camera -R189- and may make it impossible to perform the calibration.

-- Switch on the Calibration Tool - Linear Laser VAS6350/3 -1- on the calibration board and align the entire Calibration Tool VAS6350A, so that the laser beam points to the middle of the vehicle height above the Audi rings.

Fig 2: Switching On Line Laser VAS 6350/3

Courtesy of AUDI OF AMERICA, LLC

-- Make sure the Audi rings are centered on the rear. Adjust the laser beam as needed.

Continue calibrating the Rearview Camera -R189-, refer to Rearview Camera -R189-, CALIBRATING .