LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 510 (Rear Doors (Sedan)) >> 58 Rear Doors >> Door Components >> Catch, Removing And Installing >> Installing

Catch, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal.

NOTE:

The striker pin backing must be position with the pins -arrows- exactly in the hole.

The striker pins must be sheared off cleanly after sliding the striker pin.

If a new part is being installed, then remove the sheared off pins from the striker pin.

-- Adjust the catch. Refer to CATCH, ADJUSTING .

scientia non olet · About LEMON Manuals