Bracket, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

There is a risk of malfunctions.

The door lock must be removed and installed together with the bracket to prevent overbending the cable when disengaging and engaging it.

The cable must be disconnected from/attached to the lever on the door lock outside of the door. Refer to Installing .

-- Remove the door trim panel. Refer to REAR DOOR TRIM PANELS .

-- Remove the inner door panel cover. Refer to DOOR INNER COVER, REMOVING AND INSTALLING .

-- Turn the operating cable on the lever -1- 90° in the direction of -arrow A- and remove it from the cable bracket -2-.

-- Rotate the actuating link on the door lock operating lever -3- in the direction of -arrow B-.

Fig 1: Removing Operating Cable

Courtesy of AUDI OF AMERICA, LLC

The cable must be aligned with the opening on the release lever.

-- Disengage the cable from the release lever.

-- Remove the outside door handle. Refer to DOOR HANDLE, REMOVING AND INSTALLING .

-- Disengage the electric wire on the mounting bracket -arrow- if applicable.

-- Free up the wire spiral clip -1- using the Pry Lever 80-200.

NOTE:

Use a soapy solution if necessary make removal easier.

-- Remove the bolt -3- and the mounting bracket -2-.

Fig 2: Electric Wire Spiral Clip, Bolt -3- & Mounting Bracket -2-

Courtesy of AUDI OF AMERICA, LLC