Fastener Tightening Specifications
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 Audi A4 Quattro, 2015 Audi A4 Quattro, 2014 Audi A4 Quattro, 2013 Audi A4, and 2012 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
| Component | Bolt Size | Nm |
|---|---|---|
| Bolts and Nuts | ||
| M6 | 9 | |
| M7 | 15 | |
| M8 | 20 | |
| M10 | 40 | |
| M12 | 65 | |
| ATF Drain Plug1 | 12 | |
| ATF Pipe, Nut | 29 | |
| ATF Plug for the Hole for Checking and Filling1 | 30 | |
| Drive Axle Heat Shield | 23 | |
| Drain Plug for the Hole for Checking and Filling for the Transmission Fluid Inside the Transfer Case | 27 | |
| Drain Plug for the Hole for Checking and Filling for the Transmission Fluid Inside the Front Final Drive | 27 | |
| Oil Drain Plug For the Transmission Fluid Inside the Transfer Case | 12 | |
| Oil Drain Plug For the Transmission Fluid Inside the Front Final Drive | 10 | |
| Selector Mechanism Function Unit to the Body, Nut | 10 | |
|
||
Driveshaft Heat Shield - Tightening Specification
NOTE:
Depending on the date of manufacture, an additional drive axle heat shield -B- may be attached.
The shape of the additional heat shield depends on the engine and on the date of manufacture.
Mark the installed position of the additional heat shield -A- before removing it.
-- Note the marking when installing the heat shield -B-.
-- Tighten the driveshaft heat shield bolts -1, 2 and 3- to 23 Nm.
Mounting Transmission to Engine
| Item | Bolt | Nm |
|---|---|---|
| 1 1) | M10 x 50 2) | 65 |
| 2 1) , 7 | M12 x 100 3) | 30 + 90° |
| 3 4) , 6 | M12 x 75 3) | 30 + 90° |
| 4, 5 4) | M12 x 120 3) | 15 + 90° |
| 8, 10 | M10 x 75 3) | 15 + 90° |
| 9 | M10 x 60 3) | 15 + 90° |
| 11 5) | M12 x 50 3) | 30 + 90° |
| A | Alignment sleeves for centering | |
|
||