Tunnel CROSSMEMBER: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 Audi A4 Quattro, 2015 Audi A4 Quattro, 2014 Audi A4 Quattro, 2013 Audi A4, and 2012 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the rear noise insulation -2-. Refer to OVERVIEW - NOISE INSULATION .

Fig 1: Identifying Noise Insulation

GWWA10-11100

Courtesy of AUDI OF AMERICA, LLC

-- Install the T10337 on the VAG 1383 A.

Fig 2: Attach To Bottom Of Transmission

GWWA37-10864

Courtesy of AUDI OF AMERICA, LLC

-- Position the T10337 on the bottom of the transmission.

-- Lift the transmission slightly using the VAG 1383 A.

WARNING:

There is the risk of an accident.

The VAG 1383 A may only be used during assembly and must not sit unsupervised under the vehicle.

-- Remove the bolts from the tunnel crossmember -arrows-.

Fig 3: Identifying Crossmember & Bolts

GWWA10-11132

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -arrow- and the tunnel crossmember.

Fig 4: Remove Nuts And Tunnel Crossmember

GWWA34-10402

Courtesy of AUDI OF AMERICA, LLC