3. Check Locking Button in the Selector Lever Handle
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 Audi A4 Quattro, 2015 Audi A4 Quattro, 2014 Audi A4 Quattro, 2013 Audi A4, and 2012 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Make sure locking button moves easily.
- It must be possible to press the locking button without using great force.
- After releasing, the locking button must come all the way back out by itself.
-- Check the selector lever handle for correct installation if the specified values are not reached. Refer to SELECTOR LEVER HANDLE .
-- Check if the selector rod or selector lever is bent.
Function test:
- The ignition is switched on.
The locking button on the selector lever handle must be pressed for the following shifts. If it is not pressed, the selector lever cannot be shifted into the specified position.
- Move the selector lever from P into R and press the brake pedal at the same time.
- D into S
- N into R; stationary, press the brake pedal after waiting longer
- R into P
-- Check the selector lever handle for correct installation if the specified values are not reached. Refer to SELECTOR LEVER HANDLE .
-- Perform Guided Fault Finding using the vehicle diagnosis tester and check the shift lock solenoid.
-- Adjust the selector lever cable. Refer to SELECTOR LEVER CABLE, ADJUSTING .