Fuel Filler Door Unlock Motor -V155-, REMOVING AND INSTALLING

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Fuel Tank Lid Unlock Motor

Courtesy of AUDI OF AMERICA, LLC

Emergency Release Cable
- Routing -item 2- "Emergency Release Cable"
Fuel Filler Door Unlock Motor -V155-
- Removing:
  -- The fuel filler door is removed.
  
  -- Pull the Comfort System Central Control Module -J393- into the luggage compartment and pull it forward.
  
  -- Remove the Fuel Filler Door Unlock Motor -V155- forward off the body flange and disconnect the electrical connector.
- Installing:
  -- Slide the Fuel Filler Door Unlock Motor -V155- onto the flange and slide the emergency release into the luggage compartment.
Fuel Filler Door
- Removing:
- Must be replaced after removing. Refer to FUEL FILLER DOOR, REMOVING AND INSTALLING
  -- Open the door and remove the bolt.
  
  -- Pull the bolted side of the door out of the side panel slightly.
  
  -- Completely remove the door from the side panel diagonally toward the rear.
- Installing:
  -- Guide cable through opening in fuel filler door cup.
  
  -- Insert fuel filler door diagonally until catches on protruding flange engage in side panel.
  
  -- Bolt the door and the door release motor together using the bolt -4-.
Bolt
- 1.7 Nm
Fuel Filler Door Cup
Drain Hose

Fuel Filler Door Emergency Release

Fig 2: Fuel Filler Door Emergency Release

Courtesy of AUDI OF AMERICA, LLC

Fuel Filler Door Unlock Motor -V155-
Emergency Release Cable
- Insert the Fuel Filler Door Unlock -V155- ash sown with the cable over the tank opening.
- Pull the cable back into the vehicle interior and connect it with the tab on the flange on the Comfort System Central Control Module -J393-.
Side Panel