Condensation Water Drain, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition.

-- Remove the glove compartment (for the right condensation water drain). Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .

-- Remove storage compartment on driver side (for the left condensation water drain). Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .

-- Carefully fold the carpet near the condensation water drain hose (left or right) far enough back, so that the condensation water drain is visible. Refer to Passenger Compartment Trim .

-- Check the condensation water drain hoses -B- that they are properly routed and for dirt. Correct, for example, if the hose is constricted.

Fig 1: View Of Condensation Water Hoses Drains, Drain Hoses And Floor Drain Openings

Courtesy of AUDI OF AMERICA, LLC

-- Cover the area under both openings -D- (for condensation water drain -C-) with absorbent paper (so that any water present does not get under the carpet).

-- Remove both condensation water drain hoses -B-.

-- Check both A/C condensation water drains -A- for soiling (for example, using a piece of wire).

-- Check the gap between the insulation mat installed in the center tunnel -E- and the end of the condensation water hose -C- above the openings -F- in the floor panel -D- ; the gap must be large enough so that the condensation water can flow out of the hose -B-.