Replacing Tool Head

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Select the appropriate tool head based on the antenna wire test. Refer to CHECKING THE ANTENNA WIRE .

-- Open the handle on the pliers all the way.

-- Release and remove both locking pins in direction of -arrows- from the handle.

Fig 1: Disengaging Crimping Tool Locking Pins

Courtesy of AUDI OF AMERICA, LLC

-- Attach the necessary tool head to the handle from the top in direction of -arrow-.

Fig 2: Identifying Insertion Of Crimping Tool Head

Courtesy of AUDI OF AMERICA, LLC

-- Insert the pins in direction of -arrows- into the handle in order to lock the tool head into place.

Fig 3: Engaging Crimping Tool Locking Pins

Courtesy of AUDI OF AMERICA, LLC