Vehicle Diagnostic Tester, CONNECTING
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Vehicle Diagnostic Tester and diagnostic cable
Procedure
-- Engage the parking brake or operate the electromechanical parking brake.
-- Shift the shifter lever into neutral or place the selector lever in the "P" position.
-- Turn off the ignition and connect the Vehicle Diagnostic Tester to the Data Link Connector (DLC) with the diagnostic cable -arrow-.
-- When using the Remote Diagnosis Head VAS5054A or the Diagnosis Interface VAS5055 pay attention to the Operating Instructions.
-- Turn on the ignition.
-- Turn off all electrical consumers.
NOTE:
If a error message appears on the screen of the Vehicle Diagnostic Tester. Refer to the Operating Instructions.