RELAY/FUSE CARRIER MOUNT WITH Vehicle Electrical System Control Module -J519-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Relay/Fuse Panel Mount With Vehicle Electrical System Control Module

Courtesy of AUDI OF AMERICA, LLC

-- Remove the left side instrument panel vent. Refer to INSTRUMENT PANEL VENT, REMOVING AND INSTALLING .

-- Remove the screw -arrow- on the air duct -1-.

NOTE:

It is not necessary to remove the air duct.

-- Remove the Vehicle Electrical System Control Module -J519-. Refer to Vehicle Electrical System Control Module -J519-, REMOVING AND INSTALLING .

Fig 2: Removing Fuse Panel Mount

Courtesy of AUDI OF AMERICA, LLC

-- Slide the extension with the socket between the air duct -3- and central tube -4- and remove the nut -2-.

-- Remove the nut -5- using the socket on the extension -6- as illustrated.

-- Remove the mount from the threaded pins.

-- Disengage the retaining pins -1- on the mount at the side guide in the A-pillar -arrow- while pulling the mount toward the passenger compartment.