Special Purpose Vehicle Control Module -J608-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Comfort System Central Control Module Retaining Frame

Courtesy of AUDI OF AMERICA, LLC

-- With the ignition switched off, disconnect the battery ground cable. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Open the right luggage compartment side trim panel cover.

-- Remove the nuts -arrows- and move the frame -1- with the Comfort System Central Control Module -J393- to the side.

-- Release the clips -arrows-, if equipped, and remove the Electronic Damping Control Module -J250- -item 1- from the retaining frame.

Fig 2: Removing Electronic Damping Control Module

Courtesy of AUDI OF AMERICA, LLC

-- Remove the screws -1- and -2- and the nut -4-.

Fig 3: Identifying Frame, Bolts & Nut

Courtesy of AUDI OF AMERICA, LLC

-- Tilt the retaining frame -3- with control modules to the side.

-- Disconnect the connectors from the control modules in the retaining frame.

-- Remove the retaining frame with control modules.

-- Press the clip -1- in direction of the -arrow A- and tilt the Special Purpose Vehicle Control Module -J608- -item 2- in direction of the -arrow B- out of the frame -3-.

Fig 4: Removing Special Purpose Vehicle Control Module

Courtesy of AUDI OF AMERICA, LLC