Data Bus On Board Diagnostic Interface -J533-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Data Bus On Board Diagnostic Interface -J533-

Courtesy of AUDI OF AMERICA, LLC

-- Turn off the ignition and remove the key.

-- Remove the glove compartment. Refer to Storage Compartments and Covers .

-- Remove bolt -2-.

-- Pivot the Data Bus On Board Diagnostic Interface -J533- -item 3- out of the bracket -arrow-.

-- Disconnect the connector -4-.

-- Disconnect the fiber optic cable connector -1-.

-- Seal the open wiring harness connector -2- for the fiber-optic cable with the Fiber-Optic Repair Set - Connector Protective Caps VAS6223/9 -item 1-.

Fig 2: Fiber-Optic Cable Harness Connector And Protective Cap For Cable Connector VAS6223/9

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The protective cap prevents contamination of or mechanical damage to end face of fiber optic cable which would impair signal transmission.