Lane Change Assistance, Preparing For Calibration
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Calibration Tool - Spacing LaserVAS6350/2
- For distance measurement
- For information on usage. Refer to the Operating Instructions.
- Calibration ToolVAS6350
- Level
- On the Calibration ToolVAS6350
- To check the horizontal position of the Calibration ToolVAS6350
- Stop bracket
- To mount the Calibration Tool - Spacing LaserVAS6350/2 for the distance measurement
- Distance to the Calibration Tool - Wheel Center MountingsVAS6350/1 on the rear wheels: dimension -a- = 1700 ± 2 mm
- Calibration Tool - Wheel Center MountingsVAS6350/1
- with wheel bolt adapter and measuring paddle
- Brand emblem
- The laser point is aligned on the center of the brand emblem
- Calibration Tool - Lane Change Calibration ToolVAS6350/4
- is moved from one side of measuring field to the other during calibration
- when installed correctly, vehicle electrical system voltage line must be connected at bottom left of calibration device (as seen in direction of travel)
- Measurement Scale
- For positioning the Calibration Tool - Lane Change Calibration ToolVAS6350/4
- Calibration Tool - Linear LaserVAS6350/3
- With "laser eye protection"
- On the VAS6350
- Turning on and off. Refer to the Operating Instructions.
- Plastic Foot
- Quantity: 3
- Can be adjusted for adjusting the horizontal position of the VAS6350