Selector Lever Transmission Range Position Display Unit -Y26-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Prying Out Selector Lever Boot

Courtesy of AUDI OF AMERICA, LLC

-- Shift the selector lever into the "S" position.

-- Turn off the ignition.

-- Carefully pry the selector lever boot out at the side using a Trim Removal Wedge 3409 or a small screwdriver -arrows-.

-- Fold the selector lever boot upward.

-- Release the spring -2- and remove the Selector Lever Transmission Range Position Display Unit -Y26- -item 1- -arrow-.

Fig 2: Removing Selector Lever Transmission Range Position Display Unit

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector.