Overview - High Beam Assist, Humidity Sensor And Lane Assist
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Front Cover
- For the housing for the Automatic High Beam Assist Control Module -J844- with Light Recognition Sensor -G399-
- Upper Cover
- For Automatic High Beam Assist Control Module -J844-
- Interior Rearview Mirror
- Vehicles with Automatic High Beam Assist Control Module -J844- with Light Recognition Sensor -G399-
- Automatic High Beam Assist Control Module -J844- with Light Recognition Sensor -G399- integrated inside the interior rearview mirror. Cannot be replaced separately if faulty.
- Replacing the interior rearview mirror. Refer to EXTERIOR REARVIEW MIRROR .
- Upper Cover
- For Directional Stabilization Assistance Control Module -J759-
- Directional Stabilization Assistance Control Module -J759-
- Removing and installing. Refer to Directional Stabilization Assistance Control Module -J759- AND LENS SCREEN, REMOVING AND INSTALLING .
- Lower Cover
- For Directional Stabilization Assistance Control Module -J759-
- Rear Cover
- Central Connector
- Humidity Sensor -G355-
- There are different versions.
- For vehicles from MY 2010, the Humidity Sensor -G355- is integrated in the Rain/Light Recognition Sensor -G397-
Vehicles through MY 2009
- Removing and installing. Refer to Additional Components for Control and Regulation
.
Vehicles from MY 2010
- Removing and installing. Refer to Rain/Light Recognition Sensor -G397-, REMOVING AND INSTALLING, FROM MY 2010 .