Headlamp Range Control Adjuster -E102-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Headlamp Light Switch Trim

Courtesy of AUDI OF AMERICA, LLC

-- Remove the driver side instrument panel cover. Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .

-- Remove the gap cover for the instrument cluster. Refer to INSTRUMENT CLUSTER GAP COVER, REMOVING AND INSTALLING .

-- Remove the bolts -arrows- and the light switch trim -1-.

-- Disconnect the connector for the Light Switch -E1-.

NOTE:

The illustration shows the Light Switch -E1- removed.

-- Press the release button and disconnect the connector -1- from the Headlamp Range Control Adjuster -E102-.

Fig 2: Disconnect The Electrical Connector -1- From The Headlamp Range Control Adjuster -E102- By Pressing The Release Button

Courtesy of AUDI OF AMERICA, LLC

-- Carefully release the retaining hooks -arrows- using a small screwdriver.

-- Remove the Headlamp Range Control Adjuster -E102- -item 2- from the light switch trim.