Cigarette Lighter -U1-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

CAUTION:

Risk of injury.

After removing the Cigarette Lighter Release Tool T40148, check to see if the lighter retaining tabs are bent.
If the retaining tabs are bent, bend them back so the lighter does not slide out.

-- Remove the support -1- on the Cigarette Lighter Release Tool T40148.

Fig 1: Identifying Support, Thumbwheel, Release Tabs, Release Tool T40148 & Cigarette Lighter

Courtesy of AUDI OF AMERICA, LLC

-- Slide the piston down and hold it in place.

-- Turn the thumbwheel -4- on the Cigarette Lighter Release Tool T40148 counter-clockwise -arrow-. While doing so, the release tabs -2- are loosened on the Cigarette Lighter -U1- -item 3- and the Cigarette Lighter Release Tool T40148 can be removed.

-- Slide the cigarette lighter illumination ring into the mount until the retaining clips engage.

The illumination ring can only be inserted into the mount in one position.