Steering Wheel, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Applies to vehicles equipped with dynamic steering:

Before the steering wheel can be removed from the steering column, the steering wheel must be in the exact horizontal using the Steering Wheel VAS6458. Mount the new steering wheel so that it is horizontal using the Steering Wheel Scales VAS6458.

After doing this step, the Steering Angle Sensor -G85- for setting the steering wheel position must be checked. While doing this, select the appropriate measured values block in the Steering Column Electronics Control Module -J527- in on board diagnostics. If the displayed value is > 0.5°, then the Steering Angle Sensor -G85- must be calibrated again and the dynamic steering must be readapted. Select the appropriate program in Guided Fault Finding. Refer to DYNAMIC STEERING BASIC SETTING .

-- Straighten the wheels.

-- Position the steering wheel as far upward as possible using the full range of the steering column adjuster.

-- Remove the airbag unit. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING .

NOTE:

Removal and installation of steering wheel must take place in center position (wheels in straight-ahead position).

-- Remove bolt -2-.

Fig 1: Identifying Bolt And Steering Wheel

Courtesy of AUDI OF AMERICA, LLC

-- Mark position of steering wheel/column with a felt-tip pen.

-- Remove steering wheel -3- from steering column.