Electromechanical Steering Gear, Removing And Installing: Notes

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Torque Wrench 1331 5-50Nm VAG1331
Torque Wrench 1332 40-200Nm VAG1332
Torque Wrench 1332 Insert - Ring Wrench - 21mm VAG1332/7
Puller - Ball Joint T40010A

NOTE:

Power steering gear is completely removed and installed with tie rods.

A removable heat shield mat was installed on the steering gear at start of production. Be sure to install this mat if installing the old steering gear again.

A removable heat shield mat on the steering gear was replaced by a bonded heat shield mat as a running change. It is therefore not necessary to take the mat from the old steering gear and installing on a new steering gear.

A replacement steering gear comes with the bonded heat shield mat.