Headlamp Housing Mount Bracket, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Pulling Air Guide Off Air Filter Housing

Courtesy of AUDI OF AMERICA, LLC

-- Remove the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .

-- If equipped, remove the bolts -arrows- and detach air duct -1- at the left and right from the air filter housing.

-- Remove the headlamp housing. Refer to HEADLAMP, REMOVING AND INSTALLING .

-- If equipped, remove the headlamp washer system spray nozzle. Refer to HEADLAMP WASHER SYSTEM .

-- Disconnect the connector to the front airbag crash sensor. Refer to AIRBAG CRASH SENSORS .

-- Remove the bolts -1, 2, and 3-.

Fig 2: Headlamp Housing Mount Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Release the tab -5- -arrow- and remove the bracket -4- from the lock carrier.

-- If the bracket is being replaced:

Remove the headlamp housing mount. Refer to HEADLAMP HOUSING MOUNT, REMOVING AND INSTALLING .
Removing the front airbag crash sensor. Refer to AIRBAG CRASH SENSORS .