Headlamp Housing Mount Bracket, Adjusting
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Adjusting Tool T40281
Procedure
-- Remove the lock carrier cover. Refer to LOCK CARRIER COVER, REMOVING AND INSTALLING .
-- Remove the bolt -4-.
-- Loosen or tighten the adjusting nut -5- in stages using the Adjusting Tool T40281 -arrows- until the gap dimension of the bumper cover -2- to the hood -3- and headlamp -1- is reached.
- Dimension -a- = 4.5 mm
- Dimension -b- = 2.0 mm
- Dimension -c- = 2.0 mm
-- Tighten the bolt.
-- Check the gap dimensions again and repeat the adjustment as first described, if needed.
- Tightening specification. 8 Nm