End Panel, Removing And Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying End plate Components

Courtesy of AUDI OF AMERICA, LLC

Fender
End Plate
-- Remove front wheel.

-- Remove the rear part from the wheel housing liner. Refer to REAR WHEEL HOUSING LINER, REMOVING AND INSTALLING .
- Loosen the windshield washer fluid reservoir on the left side
  -- Remove the bolts -3-, unclip the end plate from the fender rear bracket and slide it downward. Refer to -item 6- Rear Bracket (See Figure).
Bolts
- 1.5 Nm
Clip
- Quantity: 2

Unclip the End Plate

Fig 2: Identifying End Plate Components

Courtesy of AUDI OF AMERICA, LLC

-- Before the end plate -1- can be removed downward, it must first be unclipped from the bracket -arrow- for the fender -2-.