Driveshaft From Rear Final Drive: Removing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, and 2014 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Do not bend the decoupling element in the front exhaust pipe more than 10°, otherwise it will get damaged.

-- Loosen the clamping sleeve(s) -arrows- and disconnect the exhaust system.

Fig 1: Clamping Sleeve Threaded Connections

Courtesy of AUDI OF AMERICA, LLC

-- Tie the front exhaust pipe(s) to the underbody.

NOTE:

A second technician will be needed to help remove the rear section of the exhaust system.

-- Remove rear portion of exhaust system. Refer to EXHAUST PIPES/MUFFLERS for engine code CALA, EXHAUST PIPES/MUFFLERS for engine codes CAED, CAEB, CPMB, CPMA, or EXHAUST PIPES/MUFFLERS for engines CCBA, CGXC, CTUB .

-- Check whether there is a marking (color marking) on driveshaft and at flange/driveshaft at rear final drive -arrow A- and -arrow B-.

Fig 2: Identifying Mark Position Of Driveshaft Flange To Rear Final Drive

Courtesy of AUDI OF AMERICA, LLC

-- If one of these markings is no longer visible (for example -arrow A- on the driveshaft), then make a new color marking.

Die marking on the driveshaft -arrow A- and on the rear final drive -arrow B- must line up.

-- Remove the bolts -1- (quantity: 6) from the rear CV joint.

Fig 3: Removing/Installing Driveshaft Bolts -1- At Rear Final Drive Using Counterhold Tools

Courtesy of AUDI OF AMERICA, LLC

-- Use the T10172 with the T10172/5.

-- Remove the driveshaft from the rear final drive and tie it to the subframe.