Brake Lamp Sensor, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

The stop -17- on the brake pedal is an assembly aid during production and does not need to be installed again.

Fig 1: Brake Pedal Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

NOTE:

When installing the brake lamp sensor, the plunger adjusts itself automatically.

The brake pedal must remain in end position during installation and must not be moved.

The brake pedal must be connected with the brake booster.

-- Insert the brake lamp sensor in the mount on the brake pedal and press it in lightly.

NOTE:

The brake lamp sensor must engage audibly with all three retaining tabs.

The switch must not be rotated in the mount on the brake pedal.

When installing the brake lamp sensor, the plunger adjusts itself automatically.

-- Rotate the colored piece on the brake lamp sensor to the right as far as the stop to secure the switch.

-- Connect the electrical connector.

-- Install the footwell vent -A - B-.

Fig 2: Identifying Footwell Vents

Courtesy of AUDI OF AMERICA, LLC

-- Connect the connector -C- for the footwell vent.

-- Install the driver side storage compartment -1 to 3-.

Fig 3: Identifying Driver Side Storage Compartment

Courtesy of AUDI OF AMERICA, LLC

Check the brake lamp sensor function after installing it and before driving.