Wheel Bearing Unit, All Wheel Drive (AWD), Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Bolts And Wheel Bearing Unit

Courtesy of AUDI OF AMERICA, LLC

-- Remove wheel bearing housing. Refer to WHEEL BEARING HOUSING, ALL WHEEL DRIVE (AWD), REMOVING AND INSTALLING .

-- Clamp the wheel bearing housing in a vise with protective covers.

-- Remove the bolts -1- and the wheel bearing unit -2-.

Fig 2: Avoid Contaminating With Dirt And Damaging Seal When Setting Down/Storing

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Avoid contaminating with dirt and damaging the seal when setting down/storing.

The wheel bearing -1- must face up in order to remove the wheel bearing unit.
Always set the wheel bearing unit down on the wheel hub -2-.
Never reach into the inside when lifting the wheel bearing.

Fig 3: Correct & Incorrect Holding Of Wheel Bearing
Courtesy of AUDI OF AMERICA, LLC
Hold the wheel bearing only on the outside.

The same procedure also applies to the wheel bearing without a wheel hub.