Front Bonded Rubber Bushing, Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Rubber Bonded Bushing

Courtesy of AUDI OF AMERICA, LLC

-- Remove the wheel bearing housing. Refer to WHEEL BEARING HOUSING, REMOVING AND INSTALLING, FRONT WHEEL DRIVE (FWD) VEHICLES .

In order to remove the front rubber bonded bushing, the Bearing Installer - Wheel Bearing Bushing - Pressure Plate T40184/2 -3- must be mounted on the front rubber bonded bushing in such a way so that the lugs -2- fit into the grooves -4-.

-- Place the tools on the front bonded rubber bushing and the wheel bearing housing as illustrated.

Fig 2: Place Tools On Front Bonded Rubber Bushing And Wheel Bearing Housing As Illustrated

Courtesy of AUDI OF AMERICA, LLC

NOTE:

When mounting the wheel bearing housing onto the Sleeve T40184/1 be careful not to damage or push the rubber grommet on the rear rubber bonded bushing.

Press Piece - Rod VW411
Bearing Installer - Wheel Bearing Bushing - Pressure Plate T40184/2
Wheel bearing housing
Sleeve T40184/1. The side with the groove must face the wheel bearing housing. On a bonded rubber bushing with a "positioning tab", this is in the groove on the Sleeve T40184/1.

-- Press out the front rubber bonded bushing.