Overview - Drive Axle With 88/98 Mm Diameter Outer CV Joint And Drive Axle With 100/108 Mm Diameter Inner CV Joint With Cap: Notes
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Drive Axle Overview, With 88/98 Mm Diameter Outer CV Joint And 100/108 Mm Diameter Inner CV Joint With Cap
- Cover
- Carefully remove the cover using a drift, replace if damaged.
- The adhesive surfaces on the cover/inner CV joint must be free of grease when installing.
- Coat the sealing surface with Sealant before installing the CV joint.
- Locking Ring
- Remove and install using commercially available locking ring pliers.
- Always replace if removed
- Inner CV Joint
- Replace only as complete unit.
- Checking. Refer to INNER CV JOINT, CHECKING .
- Grease quantity and type. Refer to GREASE QUANTITY AND TYPE (88/89MM & 100/108MM) .
- The adhesive surfaces must be free of oil and grease
- When installing joint on axle shaft, splines on axle shaft must be lightly coated with grease used in joint.
- Inner CV Boot with Cap
- Without vent hole
- Carefully remove the cap using a drift, replace if damaged.
- Check the inner CV joint if there is damage. Refer to INNER CV JOINT, CHECKING .
- The sealing surfaces on the cap/inner CV joint must be free of grease when installing.
- Locking Plate
- Bolt
- 70 Nm
- M 10
- Always replace if removed
- Clamp
- Always replace if removed
- Tensioning. Refer to TIGHTENING CLAMPS ON INNER JOINT .
- Drive Axle
- Removing and installing. Refer to DRIVE AXLE, REMOVING AND INSTALLING .
- Clamp
- Always replace if removed
- Tensioning. Refer to INSTALLING CLAMP ON 88 MM OR 100 MM DIAMETER OUTER JOINT .
- Outer CV Boot
- Without vent hole
- Check for tears and chafing; replace if necessary
- The protective boot/metal cap sealing surfaces must be free of grease when installing.
- The protective boot/drive axle sealing surfaces must be free of grease when installing.
- Clamp
- Always replace if removed
- Tensioning. Refer to INSTALLING CLAMP ON 88 MM OR 100 MM DIAMETER OUTER JOINT .
- Locking Ring
- Always replace if removed
- Insert before mounting in ring groove (not visible with joint installed)
- Before installing CV joint, align sealing ring in center with opening facing upward.
- Outer CV Joint
- Replace only as complete unit.
- Removing. Refer to DRIVE AXLE, DISASSEMBLING AND ASSEMBLING, DRIVE AXLE WITH 88 MM OR 100 MM DIAMETER CV JOINT .
- Installing: Drive onto shaft with plastic mallet until the compressed circlip seats.
- Circlip must lie in joint chamfer when guiding in, guide with pliers if necessary.
- Grease quantity and type. Refer to GREASE QUANTITY AND TYPE (88/89MM & 100/108MM) .
- The protective boot/CV joint sealing surfaces must be free of grease when installing.
- When installing joint on axle shaft, splines on axle shaft must be lightly coated with grease used in joint.
- Bolt
- 200 Nm +180°
- Always replace if removed
- Follow the assembly information when loosening and tightening. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .