Outer CV Joint, Checking

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

It is necessary to disassemble the joint whenever replacing the grease or if the ball surfaces show wear or damage.

Disassembling

-- Mark position of ball hub to ball cage and to housing before disassembling, using electro-writer or grindstone.

Fig 1: Ball Hub And Ball Cage Swiveled

Courtesy of AUDI OF AMERICA, LLC

-- Swivel the ball hub and ball cage.

-- Remove the balls one after the other.

-- Turn cage, until two rectangular windows -arrow- contact joint body.

Fig 2: Identifying Rectangular Windows Aligned With Joint Housing

Courtesy of AUDI OF AMERICA, LLC

-- Lift out cage with hub.

-- Swing hub segment with smaller pins into rectangular window on cage.

Fig 3: Hub & Cage

Courtesy of AUDI OF AMERICA, LLC

-- Fold hub out from cage.

Checking

The balls of each joint belong to one tolerance group. Check stub axle, hub, cage and balls for small depressions (pitting build-up) and chafing. Excessive circumferential backlash in joint makes itself noticed via tip-in shock, in such cases joint should be replaced. Flattening and running marks of balls are no reason to replace joint.

Assembling

-- Insert cage with hub into joint body.

NOTE:

Cage must be installed laterally correct.

-- Press in opposing balls in sequence, during this, previous position of ball hub to ball cage and to joint body must be established again.

-- Press grease into joint body.

Grease capacities and types, drive axle with 88 mm diameter or 100 mm diameter outer CV joint. Refer to GREASE QUANTITY AND TYPE (88MM & 100MM) .