Flat Spots In Tires From Standing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Flat spots in tires from standing can also cause vibration.

What is a flat spot from standing?

Terms like flat portion and flattening are also used as a term for flat spots from standing.

It is important to recognize a flat spot in the tread from standing as such!

NOTE:

It is not possible to balance a flat spot.

Flat spots can occur again caused by many different reasons. Flat spots from standing can be corrected without complicated special tools. Providing that the flat spot was not caused by wheel lock during hard braking, refer to WEAR SPOTS .

NOTE:

Wear spots due to wheel lock are irreparable! Tires with such damage must be replaced.

Causes of flat spots from standing:

The vehicle has been standing for a long time in one place without being moved.
Tire pressure is too low.
The vehicle was placed in a paint system drying cabinet after painting.
The vehicle was parked with warm tires in a cold garage or similar for a long time. In this case, a flat spot can develop overnight.

Flat spots, correcting:

Flat spots cannot be removed from tires with workshop equipment.
Flat spots cannot be balanced out.
Check and correct the tire pressure as necessary.
Such flat spots can be "driven out" only by driving the car until the tires are warm.
We recommend driving the tires warm and not in cold or winter weather.

CAUTION:

Do not endanger yourself or other persons during this road test.

Observe valid traffic laws and speed limits during the road test!