Installing/Conditions For Using Run-Flat Tires
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Because pressure loss in a run-flat tire is not always visible, these tires should only be used on vehicles equipped with a tire pressure monitoring system. This system warns the driver when the tire pressure falls below a certain value.
The following are permitted:
- Direct measuring systems
- Indirect measuring systems
Only mount run-flat tires on disc wheels with an extended double hump (extended hump - EH2).
Pay close attention to the installation instructions.
Do not install both run-flat tires and standard tires, even if the two tires on each axle will be the same.
A standard tire can only be installed in exception cases for a short time or a limited driving distance. The specific characteristics designed for driving with a flat tire will not be available. The driver must be informed of this.