LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 494 (Wheels & Tire General Information (Sedan)) >> 44 Wheels, Tires, Wheel Alignment >> Balancing >> Stationary Balancing Machine

Stationary Balancing Machine

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required 

NOTE:

Please keep in mind that cleanliness is the most important when balancing as well, just as for any other repairs you perform. Only then can a proper result be obtained!

CAUTION:

The balance weights must be glued on so that rub against the brake caliper or the suspension.

-- Tension wheel on balancing machine.

NOTE:

Wheels with a sensitive surface, glued-on wheel trim, refer to WHEELS WITH A SENSITIVE SURFACE, GLUED-ON WHEEL TRIM .

NOTE:

Be careful not to scratch off the glued- on wheel trim on these rims.

The surface of the wheel trim is very sensitive.

The rim will have be replaced if the wheel trim is damaged.

The wheel trim cannot be replaced.

Fig 1: Identifying Wheel Rims With Glued-On Wheel Trim
GWWA44-10265Courtesy of AUDI OF AMERICA, LLC

Dirt and rust in the area of the contact surfaces and centering of the wheel distort the result.

-- Clean contact surfaces, centering seat and wheel disc before tensioning wheel on balancing machine!

-- Tension wheel with tire on balancing machine.

CAUTION:

The balance weights must be glued on so that rub against the brake caliper or the suspension.

NOTE:

To mount wheel on wheel balancer use, for example, the Wheel Centering System Adapter VAS5271.

Fig 2: Centering System For Wheel Balancing Machines VAS 5271
GWWN44-10208Courtesy of AUDI OF AMERICA, LLC

This way a 100% centering of the wheel and gentle mounting is possible!

It is not possible to center it 100% on balancing machine with conical pensioners.

With a deviation of 0.1 mm outside the center, there is an imbalance of 10 grams on the wheel/tire.

NOTE:

Use Wheel Balancer Clamping Adapter - 5 Lug VAS6243 to gently mount a wheel on the wheel balancer.

This way improved balance results are attained and the surface of the rim is protected, for example, on chrome wheel rims.