Measurement Preparations
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Brake Pedal Actuator VAG1869/2.
- Steering Wheel Scales VAS6458
- Vehicle Diagnostic Tester
- Wheel Alignment Computer
The measurement sensor must be properly adjusted and attached to the vehicle; observe device manufacturer's operating instructions.
Make sure that the sliding plates and turn tables are not touching the end stop when checking the wheel alignment.
Drive the vehicle onto the alignment rack without tension. Move the vehicle back and forth if necessary to relieve any tension on the axle components.
The steering wheel must be "evened out" into the center position before beginning the measuring and adjusting. Use Steering Wheel Scales VAS6458 for this.