Tire Pressure Sensor -G222- / -G223- / -G224- / -G225-, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Replace damaged sensors.

When using used tire pressure monitoring sensors, check the connection between the sensor and the valve for damage.

For safety reason, replace the tire pressure monitoring sensor and clean the rim after using tire sealant.

Do not clean the tire pressure sensors with steam jet cleaners or strong compressed air.

When sliding the new seal and sealing washer on, prevent the valve body from being pressed through by counter-holding it (the antenna connection could be damaged).

-- Insert the sensor -2- with the new seal and sealing washer through the rim from the inside and press the seal into the valve bore. Make sure the valve shaft is in the center inside the valve hole.

Fig 1: Identifying Union Nut And Tire Pressure Sensor

Courtesy of AUDI OF AMERICA, LLC

-- Install the union nut -1- on the tire pressure sensor -2-. When doing this, press the sensor into the bed and hold it there.

CAUTION:

When tightening the union nut, avoid excessive pressure on the nut and on the tool

-- Press the tire pressure sensor -1- onto the rim and tighten the union nut. Refer to OVERVIEW - TIRE PRESSURE SENSOR .

Fig 2: Pressing Tire Pressure Sensor Onto Rim Well And Locating Union Nut

Courtesy of AUDI OF AMERICA, LLC

NOTE:

After installing, tire pressure sensor must lie firmly in its bed.

Sealing washer -arrow- becomes slightly deformed when doing this.