Tire Pressure Monitoring Control Module 2 -J502-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Inserting Center Console With Pins -1- Into Instrument Panel -2-

Courtesy of AUDI OF AMERICA, LLC

Installation is the reverse of removal, with special attention to the following:

-- If the center console was pulled out of the instrument panel when pulling the carpet back, insert the center console with the pins -1- in the instrument panel -2-.

-- Tighten the nuts -1- to 2 Nm.

-- The system must be coded again if the Tire Pressure Monitoring Control Module -J502- is replaced. Refer to TIRE PRESSURE MONITORING SYSTEM, SYSTEM DESCRIPTION and Vehicle Diagnostic Tester.