Overview - Dynamic Steering
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Additional information on dynamic steering can be found in Self Study Program 402 Audi Dynamic Steering.
- Power Steering Pump
- Only for vehicles with hydraulic power steering
- With an electric control valve
- The control valve is only installed on vehicles with 6- and 8-cylinder engines.
- The power steering pump and control valve are one component and are replaced together.
- On 4- and 6-cylinder vehicles: installed on the front of the engine on the left side (belt drive)
- On 8-cylinder vehicles: installed on the back of the engine on the left side (chain drive)
- Actuator
- Must not be loosened or removed from the steering column.
- The actuator and steering column are one component and are replaced together.
- The system must be calibrated if the actuator is replaced. Refer to DYNAMIC STEERING BASIC SETTING .
- Removing and installing. Refer to STEERING COLUMN, REMOVING AND INSTALLING .
- Active Steering Control Module -J792-
- The system must be calibrated if the Active Steering Control Module -J792-. Refer to DYNAMIC STEERING BASIC SETTING .
- Removing and installing. Refer to Active Steering Control Module -J792-, REMOVING AND INSTALLING .