Active Steering Control Module -J792-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

The Active Steering Control Module -J792- is located in the footwell under the driver seat.

Before removing control module, read out code using Guided Fault Finding in "Replace control module" function.

-- Loosen the driver seat and slide it back with the wires connected.

-- Remove the sill panel. Refer to SILL PANEL STRIP, REMOVING AND INSTALLING .

-- Remove the foot rest. Refer to FOOT REST, REMOVING AND INSTALLING .

-- Disengage the carpet and support it using a suitable wood block -6-.

Fig 1: Disengage Carpet And Support It Using A Suitable Block Of Wood

Courtesy of AUDI OF AMERICA, LLC

-- Remove nuts -7-.

-- Remove the nuts -1- and remove the ground wire -2- from the threaded pin.

-- Carefully disconnect the wiring harness clip connection -3- from the bracket -4-.

-- Remove the wiring harness connectors -3- from the control module -8-.

-- Remove the bolts -5- from the control module -8- and remove the bracket -4-.