Active Steering Control Module -J792-, REMOVING AND INSTALLING: Installing
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Installation is the reverse of removal, with special attention to the following:
Follow the sequence when installing the control module:
-- Tighten the bracket -4- with the bolts -5- to the control module -8- to 8 Nm.
-- Connect the wiring harness connectors -3- to the control module -8-.
-- Carefully slide the wiring harness clip connection -3- into the bracket -4-.
-- Insert the control module with the bracket.
-- Connect the ground wire -2- to the threaded pin and tighten the nuts -1- to 6 Nm.
-- Tighten the nuts -7- to 6 Nm.
-- The system must be calibrated if the Active Steering Control Module -J792-. Refer to DYNAMIC STEERING BASIC SETTING .
Tightening specifications:
Fig 2: Identifying Nut -1-, Bolts -2-, Control Module -3-, Connector Wiring Harness -4-, Ground Wire -5- And Bracket -6-
| Component | Nm |
|---|---|
| Bracket -6- and ground wire -5- (integrated in the connector wiring harness -4-) with the nut -1- to the threaded pin | 6 |
| Bracket -6- with bolts -2- to the control module -3- | 8 |