Vacuum Pump, Removing And Installing, 2.7L TDI And 3.0L TDI Diesel Engine: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Replace the seal.

Make sure the seal is correctly installed.

-- Install the vacuum line on the removed vacuum pump.

Make sure it is installed in the correct position

-- Position the vacuum pump tappet so it engages in the groove on the camshaft when vacuum pump is installed.

-- Insert the vacuum pump.

-- Make sure the seal is seated correctly.

-- Install and tighten all the bolts on the vacuum pump sealing flange, refer to Figure, -item 1- Bolt.

-- Place the vacuum line into the plenum chamber bulkhead.

-- Connect the vacuum line and vacuum hose behind the plenum chamber bulkhead.

-- Install the plenum chamber cover. Refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .

-- Install the engine cover.