Overview - Electric Vacuum Pump, RS 5
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
The Brake System Vacuum Pump -V192- is switched on by the engine control module depending on the intake manifold pressure.
NOTE:
To remove the vacuum pump, the left front wheel housing liner must be removed. Refer to WHEEL HOUSING LINER .
View of the Brake System Vacuum Pump -V192- from below after removing the left front wheel housing liner
- Bracket
- Remove the Brake System Vacuum Pump -V192- to remove.
- Removing and installing. Refer to ELECTRIC VACUUM PUMP BRACKET, REMOVING AND INSTALLING, RS 5 .
- Bracket Bolt
- 20 Nm
- Connector
- Brake System Vacuum Pump -V192-
- Removing and installing. Refer to BRAKE ELECTRIC VACUUM PUMP, REMOVING AND INSTALLING, RS 5 .
- Checking. Refer to VACUUM SYSTEM, CHECKING, RS 5 .NOTE:
To remove the vacuum pump, the left front wheel housing liner must be removed. Refer to WHEEL HOUSING LINER .
View of Brake System Vacuum Pump -V192- in the engine compartment on the left side and in the front
- Bracket Bolt
- 20 Nm
- Brake System Vacuum Pump -V192-
- Removing and installing. Refer to BRAKE ELECTRIC VACUUM PUMP, REMOVING AND INSTALLING, RS 5 .
- Checking. Refer to VACUUM SYSTEM, CHECKING, RS 5 .NOTE:
To remove the vacuum pump, the left front wheel housing liner must be removed. Refer to WHEEL HOUSING LINER .
- Check Valve
- Removing and installing. Refer to CHECK VALVE, REMOVING AND INSTALLING, RS 5 .
- Checking. Refer to CHECK VALVE, CHECKING, RS 5 .
- Nut
- 20 Nm
- Bracket for secondary pump hose
- Bracket Bolt
- 20 Nm