Brake Electric Vacuum Pump, Removing And Installing, Except RS 5: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The electrical vacuum pump is located in the engine compartment on the right side in front of the plenum chamber bulkhead.

-- Remove the engine cover.

-- Disconnect the connector -1-.

Fig 1: Disconnecting Electrical Connector

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the clamp on the vacuum hose using suitable pliers.

-- Disconnect the vacuum hose from the vacuum pump.

-- Press the right and lift clips -arrow- out of the bracket by hand.

Fig 2: Identifying Brake System Vacuum Pump V192 Upward From Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Remove the electrical vacuum pump upward while holding the rubber buffer securely.

Fig 3: Identifying Electrical Vacuum Pump Upward

Courtesy of AUDI OF AMERICA, LLC

NOTE:

When removing the vacuum pump V192, make sure the lower rubber buffer does not fall into the engine compartment.