Overview - Front Brake Caliper, FBC, 1LA And 1LJ Brake Caliper
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Install complete repair kit when servicing.
Apply thin coat of Assembly Paste G 052 150 A2 to brake cylinders, pistons and seals.
- Bolt
- 30 Nm
- Protective Cap
- Insert in brake caliper
- Replacing. Refer to BEARING BUSHING AND GUIDE PIN, REPLACING, FBC, 1LA AND 1LJ BRAKE CALIPER .
- Guide Pin
- Slide through the boot
- Replacing. Refer to BEARING BUSHING AND GUIDE PIN, REPLACING, FBC, 1LA AND 1LJ BRAKE CALIPER .
- Protective Cap
- Install on the bleeder valve.
- Bleeder Valve
- 15 Nm
- Apply a thin coat of Assembly Paste G 052 150 A2 to the threads before screwing in.
- Brake Caliper Housing
- Spring
- Ensure installation position is correct.
- Protective Cap
- Do not damage when installing piston
- Coat with Assembly Paste G 052 150 A2.
- Piston
- Apply thin coat of Assembly Paste G 052 150 A2 to piston before inserting
- Diameter 57 mm.
- Seal
- Coat with Assembly Paste G 052 150 A2.
- Brake Carrier
- Removing and installing. Refer to BRAKE CALIPER, REMOVING AND INSTALLING, 1LA, 1LB, 1LJ AND 1LD 1ZT + S4 /S5 .
- The 4 retaining pins for the brake pads on the brake carrier must not be loosened under any circumstances.
- Bolt
- 196 Nm