LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 490 (Brake System - General & Technical Data (Sedan) (As Of 01.2014)) >> 00 General, Technical Data >> Brakes Inspection >> General Information

General Information

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

The testing takes place on a test stand.

When testing, manual transmission vehicles must be in idle and automatic transmission vehicles must be in driving position N.

Always observe the test stand manufacturer instructions.

NOTE:

Electronic brake control systems are inoperative when the ignition is switched off.

If testing equipment is needed on road tests, follow the information below:

Fig 1: Diagnostic Tester Operator Wearing Safety Belt
GWWA87-10409Courtesy of AUDI OF AMERICA, LLC
WARNING:

Distraction and testing equipment that is not secured properly increase the risk of an accident.

The passenger airbag could be dangerous if it deploys during an accident.

  • Operating testing equipment while driving is a distraction.
  • Testing equipment that is not secured probably increases the risk of injury.
  • Position the passenger's seat as far back as possible.
  • Only use the Vehicle Diagnostic Tester.
  • Testing equipment -1- must lie flat on the passenger's lap as shown in the illustration and must only be operated by that passenger (See Fig 1).