Front Final Drive Overview: Notes
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 Audi A4 Quattro, 2015 Audi A4 Quattro, 2014 Audi A4 Quattro, 2013 Audi A4, and 2012 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Clean working conditions for the automatic transmission. Refer to CLEAN WORKING CONDITIONS .
General repair instructions, refer to REPAIR INFORMATION .
- Right Flange Shaft
- Refer to RIGHT FLANGE SHAFT
- Locking Ring
- Removing and installing
- Shaft Seal
- For the right flange shaft
- Refer to RIGHT FLANGE SHAFT SEAL
- Drain Plug
- For the hole for checking and filling
- For the transmission fluid inside the front final drive
- Tightening specification -2- GEAR OIL DRAIN AND INSPECTION PLUGS OVERVIEW .
- Cover
- For the front final drive
- Pay attention to the alignment sleeves
- Adjusting Shim
- Behind the taper roller bearing outer race
- Taper Roller Bearing Outer Race
- O-ring
- On the front final drive cover
- Refer to FRONT FINAL DRIVE COVER O-RING
- Differential
- Transmission
- Shaft Seal
- For the transmission shift lever
- Refer to SELECTOR LEVER SHAFT SEAL
- Gearshift Lever
- Removing and installing, refer to SELECTOR LEVER SHAFT SEAL
- Spring Pin
- Removing and installing, refer to SELECTOR LEVER SHAFT SEAL
- Left Flange Shaft
- Bolt
- Replace
- 9 Nm plus an additional 60° turn
- Gear Carrier
- Use the circlip to attach together with the mount -17- and -18- to the left flange shaft.
- Is identified together as the left flange shaft mounting bracket.
- Bearings
- For the left flange shaft
- Circlip
- For the left flange shaft mount
- Torque Converter
- Refer to TORQUE CONVERTER
- Shaft Seal
- For the torque converter
- Refer to TORQUE CONVERTER SHAFT SEAL
- Shaft Seal
- For the left flange shaft
- Between the final drive and the transmission housing
- Refer to LEFT FLANGE SHAFT SEAL
- Adjusting Shim
- Behind the taper roller bearing outer race
- Taper Roller Bearing Outer Race
- Screw
- Quantity: 11
- Tightening specification and sequence FRONT FINAL DRIVE COVER - TIGHTENING SPECIFICATIONS AND SEQUENCE .